Editing AUC Data:

Editing is performed in the following sequence:

  1. Load the editing routine by selecting "Edit:Edit Data" from the main screen of UltraScan:
  2. Load the imported data set into the editor. For multi-wavelength data, make sure "Save to all Wavelengths" is checked, then only eac channel needs to be edited, rather than all wavelengths from the same channel individually.
  3. Holding the control button, drag/release the mouse on top of the meniscus position:
  4. Repeat for right data range limit:
  5. Select any scans for exclusion by defining the start/end range limits in the "Scan Control", or use the "Exclusion Profile" routine, if required.
  6. Select "Save Current Edit Profile", followed by "Next Triple" to proceed through all data sets in the experiment. It is not necessary to give each edit profile a name, by default, the current timestamp will be used as a edit profile name.
  7. When all triples have been edited, you can exit this routine